Water Outages in Johannesburg: How to Prepare and Protect Your Geyser and Plumbing

Last updated:

Water cuts, whether planned maintenance or an unexpected failure, are a fact of life in many Johannesburg suburbs. Running out of water is inconvenient, but the bigger risk is damage to your plumbing when the supply stops and returns. A little preparation protects your geyser, your pipes and your family. Here is what to do before, during and after an outage.

Before an outage: get ready

  • Store drinking water. Keep clean, sealed containers of water at home. A common guide is about 5 litres per person per day, but check with your municipality for current advice.
  • Fill buckets for flushing. Store extra water for toilets and cleaning, kept covered and out of reach of small children.
  • Know your main shut-off valve. Find it now, and make sure it turns easily. In an emergency you do not want to be searching for it. See our post on what to do in a burst pipe emergency.
  • Check your tanks and pumps. If you have a JoJo tank or a booster pump, make sure they are in good condition and that the float valve works properly.
  • Fix dripping taps and running toilets. They waste water and make a short outage worse.

Protect your geyser

Your geyser is the part of your plumbing most at risk during a water cut. If the supply to the tank stops and water drains out, the heating element can run dry and burn out, which is an expensive repair.

  • If the water is off for a long time, switch the geyser off at the distribution board. This stops the element running without water around it.
  • Do not drain hot water from the tank unnecessarily. The tank holds a good reserve that stays warm for hours.
  • Wait for the tank to refill fully before switching it back on. Open a hot tap in the house. When water runs steadily with no sputtering, the tank is full.
  • Check the pressure control and drip tray for leaks after the water returns. See our geyser care and maintenance post.

When the water comes back

Water returning to dry pipes can cause a sudden surge and trapped air. To protect your plumbing:

  1. Open one or two taps (ideally the one furthest from the main and one close to it) before the supply returns, so air can escape.
  2. Turn the main valve back on slowly if you closed it.
  3. Let the taps run until the flow is steady, then close them one at a time.
  4. Expect discoloured water at first. Brown or cloudy water is common after an outage as sediment is stirred up. Let it run until it clears before you drink it or use it in the washing machine.
  5. Check for leaks. Look under sinks, around the geyser and at visible joints. A water meter that keeps turning with everything off is a warning sign. See our post on hidden water leaks and high water bills.

Low pressure after an outage

Pressure can stay low for a while as the network refills. If it stays low for days, or only affects your property, the cause may be a blocked aerator, a partly closed valve or a problem in your pipes. See our post on low water pressure causes and fixes.

Don’t forget the electrical side

Power and water problems often arrive together, especially during storms. If you run a backup power system, remember that pumps and geysers are heavy loads. See our post on backup power, generators and inverters, and our summer storm season home checklist.

Warning signs to call a plumber

  • Water that stays brown or smelly for more than a day
  • A geyser that makes unusual noises, leaks or gives no hot water after the supply returns
  • Taps that spit or hammer after the water comes back
  • Damp patches, wet ceilings or a rising water bill after an outage
  • A booster pump that runs constantly or will not stop

Frequently asked questions

Should I switch my geyser off during a water cut?

For a short cut, it is usually fine to leave it. If the cut is long, or you are not sure the tank is staying full, switch it off at the board and switch it on again only once the tank has refilled.

Is it safe to drink the water straight after an outage?

Let the taps run until the water is clear first. If you are unsure about the quality, check with your municipality, or boil water you plan to drink.

Why do my pipes bang when the water returns?

Trapped air and sudden pressure can cause banging, known as water hammer. Opening taps before the supply returns usually helps. If it continues, call a plumber.

Can an outage damage my pipes?

The outage itself rarely does, but the pressure surge when water returns can expose weak joints or old pipes. Check for leaks afterwards.

Need a hand?

Supa Nova Electrical Power & Plumbing serves homes and businesses within 20 km of Maryvale, Johannesburg. We are electricians and plumbers, so one visit can sort out the power and the water. We offer free quotations, with no call-out fee: you pay labour plus a R400 travelling fee. We work Monday to Friday, 7:00 to 17:00 (Saturdays by prior arrangement) and usually respond within 1 to 2 hours.

Call us on 011 485 1324.

Leave a Comment

Your email address will not be published. Required fields are marked *