Last updated:
In a Johannesburg summer, the electrical equipment outside your house works harder than anything inside it. Gate motors, electric fences and pool pumps sit out in the sun, rain and hail, they are connected by long cable runs that pick up surges from nearby lightning, and they are expected to work through every power cut. When something fails, it usually fails at the worst time: the gate will not open in the rain, the fence alarm sounds at 2 a.m., or the pool turns green over a long weekend. This guide explains why these systems suffer in storm season and what you can do to keep them running.
Why outdoor electrics take the most punishment
- Lightning surges. A strike does not have to hit your property. A nearby strike can send a surge along the power supply and along long outdoor cables, such as a fence line or the cable to a gate motor at the end of a driveway. Electronic control boards are especially vulnerable.
- Water. Rain driven sideways by wind gets into housings, junction boxes and connections that stay dry the rest of the year.
- Heat and sun. UV light makes plastic covers brittle and cracks cable insulation, which then lets water in.
- Power cuts. Every outage drains backup batteries, and every return of power brings a risk of surges. Our post on power surges and load shedding explains why the moment power comes back is the riskiest.
- Insects and animals. Ants, lizards and rodents like warm, dry control boxes, and ants in particular can short out a circuit board.
Gate motors
Common problems
- A blown control board after a storm. The motor may hum or do nothing at all.
- A flat or worn backup battery. Most gate motors run from a battery that is kept charged by the mains. If the gate is slow, stops halfway, or dies during load shedding, the battery is often the cause. These batteries wear out after a few years, and frequent outages shorten their life.
- Water in the motor housing or the cable connections.
- Ants and debris inside the control box.
- Obstruction sensors that are misaligned or dirty, so the gate stops or reverses for no reason.
What you can do
- Know where the manual release key is and how to use it, so you are never stuck in or out when the power is off.
- Keep the area around the motor clear of grass, leaves and standing water, and make sure the cover is intact and closed properly.
- Notice when the gate starts to slow down during outages. Replacing the battery early is cheaper than being stranded.
- Do not open the control box or work on the wiring yourself. The supply to a gate motor is mains voltage.
What protects it
A gate motor should be on a properly installed supply with an earth leakage unit and good earthing. Surge protection at the distribution board helps, and a surge protector on the gate motor supply adds a further layer, especially on long driveways or where the gate has been damaged by surges before.
Electric fences
Common problems
- A damaged energiser after a nearby lightning strike.
- Vegetation touching the wires. Summer growth is fast, and branches, creepers and long grass on the fence line drain the voltage and cause false alarms.
- Broken or sagging wires and cracked insulators that short to the posts.
- Poor earthing. An electric fence relies on its earth system to work properly. Dry, hard ground in winter and corroded earth spikes both weaken it.
What you can do
- Keep the fence line clear of plants, and trim back anything growing towards it, especially before the rainy season.
- Look along the fence for broken wires, loose strain wires and cracked insulators after storms and high winds.
- Note when false alarms happen. If they come mainly during or after rain, look for vegetation or a wire touching something.
Lightning protection and compliance
A fence energiser should be installed with proper lightning protection and earthing, which gives a strike somewhere to go other than through the energiser. In South Africa, electric fences must be installed by a registered electric fence installer, and an Electric Fence System Certificate is required for fences installed or altered in recent years, and when a property with an electric fence is sold. If you are selling, ask your conveyancer what is needed. Our post on the electrical Certificate of Compliance covers the rest of the electrical side of a sale.
Pool pumps
Common problems
- The earth leakage trips when the pump starts, or only after rain. Water in the pump motor, its connections or the cable is the usual cause. See why your earth leakage keeps tripping.
- The pump hums but does not start, which often points to a failed start capacitor or seized bearings.
- The pump runs dry because the water level has dropped or the basket is blocked, which can damage the seals and overheat the motor.
- Timers that reset or lose their settings after power cuts, so the pump either runs all day or not at all.
- Pool lights with failed seals that let water in.
What you can do
- Keep the pump area dry and well drained, and keep the motor’s cooling vents clear of leaves.
- Make sure the pump is under a cover that protects it from rain but still lets air flow.
- Check the timer after every outage.
- Keep the skimmer and pump baskets clean, and keep the water level up.
- Never touch the pump, its switch or its cable with wet hands or while standing in water.
Pools and electrical safety
Water and electricity together are the most dangerous combination in a home. A pool pump and pool lights should be on a circuit protected by an earth leakage unit, with the pump, its metal parts and any metal around the pool properly earthed and bonded. If the earth leakage trips, it is warning you that current is escaping, so do not keep resetting it and do not bypass it.
And during a thunderstorm, get everyone out of the pool. Lightning and swimming do not mix.
Load shedding and backup power
If your gate motor, fence or pool pump is connected to an inverter or generator, make sure it was installed properly with a changeover switch, and that the system is big enough for the load. Pool pumps in particular draw a lot of current when they start and can overload a small inverter. Our post on backup power, generators and inverters covers the safety rules.
A storm-season checklist for outdoor electrics
- Test the earth leakage unit on your board with its test button.
- Check gate motor, pump and fence housings for cracks and gaps, and make sure covers close properly.
- Clear plants away from the fence line, gate track and pump.
- Check outdoor sockets, lights and junction boxes for cracked covers and loose conduit.
- Test the gate on battery power, and find the manual release key.
- Reset timers after outages.
- Consider surge protection at the distribution board and on outdoor equipment that has been damaged before.
For the rest of the house, see our summer storm season checklist.
When to call an electrician
Call a professional if:
- The earth leakage trips whenever the pump runs or whenever it rains
- A gate motor, fence energiser or pump stops working after a storm
- You see scorch marks, melted plastic or a burning smell at any outdoor equipment
- Outdoor cables are cracked, exposed or chewed
- You want surge protection or a new outdoor circuit installed
Frequently asked questions
Will insurance cover a gate motor or fence energiser damaged by lightning?
Many household policies cover lightning and surge damage, but conditions and excesses vary. Keep receipts, take photos, and ask for a written report on the cause of the damage to support your claim.
Why does my gate motor stop working during load shedding?
Usually the backup battery is worn out or was not fully charged between outages. A tired battery may still work when the power is on, then fail when the mains goes off.
Can I run my pool pump less to save electricity?
Often yes, with a correctly set timer, but the water still needs enough circulation and filtration. Ask your pool specialist how many hours your pool needs, and remember to reset the timer after outages.
Is it safe to swim when the pool light is not working?
A failed pool light can mean water has got into the fitting. Switch the light off at the board and have it checked before using it again.
Need a hand?
Supa Nova Electrical Power & Plumbing serves homes and businesses within 20 km of Maryvale, Johannesburg. We are electricians and plumbers, so we can check the wiring, earth leakage and surge protection on your outdoor equipment and sort out the plumbing side of a pool or pump in the same visit. We offer free quotations, with no call-out fee: you pay labour plus a R400 travelling fee. We work Monday to Friday, 7:00 to 17:00 (Saturdays by prior arrangement) and usually respond within 1 to 2 hours.
Call us on 011 485 1324 and we will get your outdoor electrics ready for the storms.
